So I bought a tool and cutter grinder...

I have shell cutters also.

I have three of the bigger wheels. I doubt anyone can use them. I cut the prices to a third of retail.
[10] 4-3 cup 10ea, [11] dish 10ea, [6] 6x1 1/2x1 1/4 20ea, [2] silicone carbide 10ea, [10] 5x2x5/8 20ea,
[8] hubs 15ea, [48] misc wheels 2.00ea
I have boxes of new , used,and reground end mills, 1 inch shank and 1 1/4 shank
I haven't gotten out to the shop to check LH or RH on the hubs.
 
Ill take 2 or 3 l.h. hubs please. Can you just confirm the taper on them if possible please? l have a boyar shultz 6-12 surface grinder and can check the actual taper tonight
 
Yep, I'll get to it tonight.
 
So, all the hubs I have are RH. Sorry. Tonight is the first time I took a hard look at them, I assumed they would be LH.
 
I also appreciate you taking a look but cannot use right hand hubs either on my Boyar Shultz. I believe they may work on one side of a Cincinnati no2 tool and cutter grinder. I have 4" extension and R.H. hub off of one one ebay right now.
 
You must log in or register to reply here.
Back
Top