Started using the new ACRA

Aukai

H-M Supporter - Diamond Member
H-M Lifetime Diamond Member
Joined
Oct 4, 2016
Messages
6,978
I got the R8 alignment pin out this afternoon, and got about half way through a pile of 316 SS gaff handles I need to drill out to 1/2". 1/4" pilot then 1/2" through hole, I did spin the 1/2" bit twice on the break through of the bottom hole.
 
Those handles look really nice. Woul like to see one with the business end installed (and maybe a little fish juice on it)
 
Thank you...
 
That mill is too clean ! :cautious:
 
Where are your chips ? :big grin:
 
Circular file, that just the floor, the rest is under the paper towels...
 
Back
Top