The Excalibur Of Pallet Discombobulators

Ulma Doctor

Infinitely Curious
Registered
Joined
Feb 2, 2013
Messages
3,539
A vision came to me in the early dawn,
The Lady of the Lake ,her arm clad in the most pure shimmering shamite, held aloft Excalibur from the busom of the water signifying by divine province that i must wield Excalibur...

CzyYBmQ0RkPGSYe4IpcMGwMNLtlT7bMSZgyurOgOBwc=w228-h640-no.jpg
The head is 2 pieces of 3/8 x 3/4" x 6" steel motor spacers welded to the angle iron backing, that is welded to a piece of 6"long hunk of scrap 2" OD square tubing and welded a 5' piece of 1 1/4" .090 wall square steel tube to the head. the fit was sloppy so i added a couple pieces of mild steel filler blocks to take up the gap. I used the PowCon 200 mig in the FCAW process Innershield 211 .045" wire

JIY6A7CGeLSIg570BaRpxW5mEGFgRza227greggWTbg=w492-h640-no.jpg

i'll be making a couple refinements and take it for a test run
#palletdiscombobulator
 
If I may be so bold as to suggest an improvement - add a semi-circle to the fulcrum point, that way you won't create as much of a dent in the wood.
 
Nice work! Looks Like it oughtta do the trick.
 
Back
Top