The Hobby-machinist Die Filer

What happened to the Mickey Mug ?:confused 3:
***G***
 
I finalized the numbers last night. I won't get anything done for a few days as they are moving my wife to the nursing Home for after-care.

Swirl Diameter --- .9375
X-Axis Spacing --- .750
Y-Axis Spacing --- .5625
Swirl Offset --- ..3750
 
Last edited by a moderator:
Glad to hear the news Bill. Hope she does well and comes home soon.
 
This board will ease the pain. I figured everything in and transposed it to this table. At any moment I will know if something is wrong and correct it.

"Billy G"


102_0969 (900 x 598).jpg
 
This may not look like a lot but it's almost 20 minutes work. It's called a "Fader Line". It is used to fill in the first row of full "Swirls". There will be one on each edge. All are completed before the "Swirls" are started. They are also just "Half Swirls". Gotta run.

"Billy G"

102_0970 (900 x 598).jpg
 
Last edited by a moderator:
102_0971 (900 x 598).jpg Could not sleep last night. I finished the edges at around 3:00AM. Nothing will get done today. I will not be home till late tonight.

"Billy G"
 
I'm optimistic Jim. The last one I did this big was 26 years ago.

"Billy G"
 
Billy Very Nice Work There. Also a grand way to keep your mind occupied. Hope all is going well for you and your wife. I will say another prayer for her.
Mark
 
Back
Top