Thoughts on unloading vmc off my trailer

[mkeller]

Done, done and done. Got it off. Went pretty well, one scare as one skate went off the ramp, was able to winch it back up and continue. Took about 3 hours start to finish. I laid al plates under the machine and put skates on it and pulled it with my jeep(4 low was perfect). One on the ramps I hooked a strap to the machine and used a come alone to inch it down the ramp, used the jeep as runaway prevention. All and all not too bad for as redneck as it ended up. Now I have to take the z motor belt off so I can drop the head to get it in my shed. Thanks for all the advise. Sorry for the cruddy pics it was dark when I remembered to snap some pics.

 

[xalky]

The worst part is over.hew:

 

[drs23]

Good job. Often helps to think it through thoroughly instead of jumping in Willy-Nilly.

Now that the niceties are over, is it time for a : YOU SUCK! yet?

 

[mkeller]

Agreed on both cases. Ive been worried about getting it off without my construction lift. Agreed about sucking, picked it up dirt cheap, but not sure of the running condition.