- Joined
- Mar 26, 2018
- Messages
- 8,407
Hi,
I am trying to get to know my Miller Diversion 180 with regard to Aluminum.
I picked up some bent scraps at the local source. All I know is it is aluminum.
I have read that some aluminum alloys can't be welded, I guess I found one.
I have had success welding aluminum so I am not a total newb. but close.
I set the dials to "Aluminum", 1/8" = 105 amps AC.
The cleaning action is normal, the puddles will not join. I wait for the puddle to develop, introduce a bit of 4043 rod .093". The rod melts but will not come together.
I used a wire wheel, cleaned with acetone as always.
Anything obvious?
Thanks,
Jeff
I am trying to get to know my Miller Diversion 180 with regard to Aluminum.
I picked up some bent scraps at the local source. All I know is it is aluminum.
I have read that some aluminum alloys can't be welded, I guess I found one.
I have had success welding aluminum so I am not a total newb. but close.
I set the dials to "Aluminum", 1/8" = 105 amps AC.
The cleaning action is normal, the puddles will not join. I wait for the puddle to develop, introduce a bit of 4043 rod .093". The rod melts but will not come together.
I used a wire wheel, cleaned with acetone as always.
Anything obvious?
Thanks,
Jeff