Van Norman Dividing Head

Sorry, I don't have the same dividing head that you do. I have the 10" vertical head. I don't know what size gear you need other than you need to have it so 40 turns of the crank turns the work 1 full revolution.
 
I recently picked up a VN dividing head (couldn't upload a photo). I was able to locate the Table of leads and index table for plates but can't find a instructions/maintenance manual. Does anyone know where I can locate or download one? The only problem that I have with the unit is the spring plunger on the crank. There appears to be a burr or something keeping the pin from engaging the plate. I'd like to take the plunger apart for repair but cannot figure out how to do it. Any help would be appreciated.

Mike
Where did you find the Table of leads and index table for plates but
 
Here you go, I think I have posted it before
 

Attachments

  • TABEL OF LEADS AND INDEX TABLE FOR PLATES.pdf
    1.6 MB · Views: 13
Thank you .
Can you tell me what the pitch of the table leadscrew is on a Van Norman mill.
Dave
 
Back
Top