- Joined
- Jun 14, 2018
- Messages
- 12
Hey everyone I got a question, I have a VFD running my 3 phase motor on my vertical mill, and it's set up bare bones, no braking resistor...the VFD runs the motor no problem....I haven't tried it yet cause I don't want to destroy anything, but can I reverse the motor on the fly without a braking resistor? Like in the instance of power tapping at low speeds...can I just hit reverse and the motor slow down then start reversing.....?? I looked through the custom functions I set up and I couldn't find anything describing this....thanks!
Nate.
Nate.