- Joined
- Nov 25, 2015
- Messages
- 8,228
BTW, don't start that grinder without ringing the wheels. You need to make sure they travelled well, and didn't get hit since it last ran.
-
Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!
What Did You Buy Today?
- Thread starter darkzero
- Start date
- Joined
- Aug 6, 2015
- Messages
- 3,859
Thanks…I did not think about that…
Looks great. Very exciting!
- Joined
- Nov 23, 2020
- Messages
- 787
New vise for the shop to replace my awful cheap big box vise. This vise is pretty slick!
- Joined
- Nov 25, 2015
- Messages
- 8,228
Bought this rotary table on craigslist today.
Paid a little more than I should have, but he won... he would not negotiate.
He insisted it was a grizzly, but it's not, it's silver, not green, and no markings.
But it is a very nice unit. no crud inside, just grease... I'll probably replace the grease with Moly.
I can't get the bearings out of the center, so I'll just clean in place before regreasing.
Oil only on the points that have oil buttons.. It's missing a set screw for the gear release. it has one, but the second is open to the elements. I may just plug it.
6" I've needed one for a while, and my makeshift ways can come to an end.
Paid a little more than I should have, but he won... he would not negotiate.
He insisted it was a grizzly, but it's not, it's silver, not green, and no markings.
But it is a very nice unit. no crud inside, just grease... I'll probably replace the grease with Moly.
I can't get the bearings out of the center, so I'll just clean in place before regreasing.
Oil only on the points that have oil buttons.. It's missing a set screw for the gear release. it has one, but the second is open to the elements. I may just plug it.
6" I've needed one for a while, and my makeshift ways can come to an end.