What does everyone think of this Mill

I got the mill home. Still on the trailer. That’s where it’s staying till I can make some room. It is filthy. Needs some minor repairs and it would be nice to reprint the table. All in all I’m happy. It’s going to be a fun project. In the end I will have a nice knee mill with some mass. I’ll post some down and dirty pics tomorrow.

Cheers everyone


Pictures or it didn't happen!
 
Congats, sounds like a solid heavy winner!!
Very exciting times as you contemplate all the new possibilities.
Whats the 1st intended project using the mill?
Best of luck getting it fit in and moved.
 
I'm afraid that table damage is irreversible and will permanently take a lot of precision out of the original machine.
 
Is that an actual step in the table or just a line from a vice sitting there for a while.
 
The damage to the table looks like it could be ground out, might be pricy though.
 
Back
Top