O
ome
Forum Guest
Register Today
Please advise on which model would serve me well. I have a 11 inch logan lathe which is 40 inches or a bit more between the centers.
I also have a grizzly g 0755 mill/drill machine with 17 inches of Z.
I would probably lean towards a 6 or 8 inch as opposed to a ten inch.
I am a novice learning about all the machines in our basement workshop.
I have a 8 inch yuasa 550-048 that has a morse taper #3, and would be cool to be able to get a low profile 3 or 6 jaw buck chuck to fit that taper. The mill has r-8 taper.
I will be learning thru Various projects, and need to get all the accessories and tooling neede for a good education.
Always helpful when i post , thank you
thanks to all of you, in advance.
Jon
I also have a grizzly g 0755 mill/drill machine with 17 inches of Z.
I would probably lean towards a 6 or 8 inch as opposed to a ten inch.
I am a novice learning about all the machines in our basement workshop.
I have a 8 inch yuasa 550-048 that has a morse taper #3, and would be cool to be able to get a low profile 3 or 6 jaw buck chuck to fit that taper. The mill has r-8 taper.
I will be learning thru Various projects, and need to get all the accessories and tooling neede for a good education.
Always helpful when i post , thank you
thanks to all of you, in advance.
Jon