So I have a Burke 126A # is blank, keyway and slot type mill. I would like to convert to at least a manual screw feed. I bought a 16” table with screw. Also have the saddle and Y screw. The knee casting had been milled in half and bolted down to make an X-Y table. I also have the knee screw and drive gears. So a bare casting might be all I need. Any one have one to sell ? Please PM me
-
Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!
WTB. Burke #4 type knee casting.
- Thread starter Marvin S
- Start date