X2 Mini Mill CNC Conversion?

jumps4

Global Moderator
H-M Platinum Supporter ($50)
Joined
Apr 30, 2012
Messages
2,241
I meant for you to message them but i did and we will see if they reply
the places i bought mine didnt have a manual. i asked both of them for it
steve
 

MGP

Active User
Registered
Joined
Apr 19, 2012
Messages
189
I meant for you to message them but i did and we will see if they reply
the places i bought mine didnt have a manual. i asked both of them for it
steve
I sent them a message requesting a manual well see what happens. Mike
 

jumps4

Global Moderator
H-M Platinum Supporter ($50)
Joined
Apr 30, 2012
Messages
2,241
i was hoping to find out how to change a buttons function but no luck
i'd like to have one to switch the step mode and i dont need return to zero button
oh well $23 i cant complain
steve
 

Capt Meatballs

Newbie
Registered
Joined
Apr 4, 2013
Messages
13
Hello guys, I'm contemplating CNCing my MicroMark X2 clone, and I found this thread super informative.

I just wanted to thank you for keeping the whole discussion on the forum, and in a language even this newbie could understand.

Ciao, Marco.
 

jimmyzoso

Newbie
Registered
Joined
May 9, 2013
Messages
3
After reading through this thread, I thought it would be useful to compile the hardware into a BOM. Here it is in both XLS and PDF.
It was set up for myself so you'll notice a couple of spots that need to be filled in that might not apply to you. e.g., 4th axis, workbench, etc.

hope it's useful!

View attachment X2 BOM.pdf
View attachment X2 BOM.xlsx
 

MGP

Active User
Registered
Joined
Apr 19, 2012
Messages
189
After reading through this thread, I thought it would be useful to compile the hardware into a BOM. Here it is in both XLS and PDF.
It was set up for myself so you'll notice a couple of spots that need to be filled in that might not apply to you. e.g., 4th axis, workbench, etc.

hope it's useful!

View attachment 53419
View attachment 53420
Hello guys sorry ive been away from this forum for a while been down due to my illness.

jimmyzoso nice pdf and exel setup that should help people find these parts a lot faster.
 

jumps4

Global Moderator
H-M Platinum Supporter ($50)
Joined
Apr 30, 2012
Messages
2,241
Hey!
good to hear from you again.
how is the mill working??
steve
 

jumps4

Global Moderator
H-M Platinum Supporter ($50)
Joined
Apr 30, 2012
Messages
2,241
I'm good
still keeping busy
steve
 
Top