X2 Mini Mill CNC Conversion?

Motor connectors wired to the controllers and shield wires grounded.
DSC00459.jpg

DSC00459.jpg
 
Last edited:
Is it ok to only use three of the four mounting holes on the breakout board?
DSC00464.jpg

DSC00464.jpg
 
Last edited:
that will be fine just make sure the cables going out are tied to the case so they cant pull on the board
steve
 
if there is no wiring diagram i'll have to draw one
nothing came with it?
steve
 
motor cables came out nice they look factory made
 
can you get me a close up of the board so i can read it?
if not i will have to go by the video
steve
 
Back
Top