Yeong Chin YCM 1 1/2VS

ejsonline

Registered
Registered
Joined
Oct 26, 2018
Messages
2
Hi guys, I'm new to this site so please forgive me as I figure out the correct approach. I'm looking for info to assist rebuilding my mill, or perhaps some diagnostic tips to establish what repairs are required. Sounds like a worn bearing but not sure, when milling.
Thanks
 
Hi, is this a Rong Fu style mill? A picture would help
A rebuild can range from very involved to very minimal- what did you have in mind and why? Spindle bearings are usually not difficult or expensive
You may need a press however
mark
 
In the states that mill is referred to as a supermax , could be others.
 
Back
Top