- Joined
- Dec 5, 2017
- Messages
- 464
Clamping kit on backorder from Grizzly, 3" rotary table should be here Thursday...
Got a 4-pack of 7/16 T nuts to give me something to bolt the vise down with.
First job with the mill was to take about 1/16th off the top of some 5/8 T nuts so my Chinese cross-feed table for my Crapsman drill press would sit down flat on the table. Apparently the T-slots on the drill press table were non-standard. Had been putting washers under the corners.
Got a 4-pack of 7/16 T nuts to give me something to bolt the vise down with.
First job with the mill was to take about 1/16th off the top of some 5/8 T nuts so my Chinese cross-feed table for my Crapsman drill press would sit down flat on the table. Apparently the T-slots on the drill press table were non-standard. Had been putting washers under the corners.