Hi everyone,
I'm looking to purchase a mill for a combination of wood and metal working. The glowing reviews about PM is making me lean in that direction. I need a decent capacity and ideally RPMs at least around the 4k range. I was looking at the 833 and 940 but neither appear to meet the speed requirement.
I took a half semester machining course where we did a little bit of milling but the lessons have atrophied since then (about 18 months ago). I will cut my teeth on this mill (not literally).
Can anyone make suggestions?
I'm looking to purchase a mill for a combination of wood and metal working. The glowing reviews about PM is making me lean in that direction. I need a decent capacity and ideally RPMs at least around the 4k range. I was looking at the 833 and 940 but neither appear to meet the speed requirement.
I took a half semester machining course where we did a little bit of milling but the lessons have atrophied since then (about 18 months ago). I will cut my teeth on this mill (not literally).
Can anyone make suggestions?