Yes, pretty much. Just did a run of the parts below. These are the parts that I built the ball turner to do. Takes about 40 minutes to run them on the manual lathe, several tool changes and setups. On the Conquest the run time is about 3 minutes, most of that time is drilling and tapping the end. Has a 5/16-18 x 1 inch deep tapped hole in the end. 304 SS, nasty stuff to work with. It is nice, put a 45 inch bar in, press go, and come back in an hour to collect the parts. And they hold +/- 0.0001 as near as I can measure.