- Joined
- Jan 29, 2014
- Messages
- 64
Earlier this year I bought me a shaper. At first I did know what brand it was but after some intensive search on the net I discovered that is was a Shape-rite 8”.
As you can see there are some parts missing, the motor for instance and a plate behind the arm, and the drive pulleys
On the net I found an engine ¾ hors power 380 volt 3 phase for 20 Eur ( 25$) The same guy had a step pulley which I could use and has about the same measurements as on the pictures I found on the net. The hole however is to large for the axle so I need to make a bushing for it.
Today I've taken everything apart except a few axles which will be removed at a later day.
Buy cleaning some of the ways I discovered the following markings “ Made in U.S.A 1089 B”
This is my new project for the next few weeks.
As you can see there are some parts missing, the motor for instance and a plate behind the arm, and the drive pulleys
On the net I found an engine ¾ hors power 380 volt 3 phase for 20 Eur ( 25$) The same guy had a step pulley which I could use and has about the same measurements as on the pictures I found on the net. The hole however is to large for the axle so I need to make a bushing for it.
Today I've taken everything apart except a few axles which will be removed at a later day.
Buy cleaning some of the ways I discovered the following markings “ Made in U.S.A 1089 B”
This is my new project for the next few weeks.