I came into a a 10" Logan lathe with a quick change tool post. I would like to order another tool holder, but I don't know what I have. The main body is marked 250-100 and is marked simply China. It is about 2 1/4 inches square, not counting the dovetail.
The knurl holder is marked 250-110, the cutoff tool is marked 250-107 and the toll holder is marked 250-101.
I have been looking at Ebay and other sellers and I think this is the BXA version. If so, are they pretty much all compatible between sellers? I don't know enough about these to even tell if it is a wedge type or piston type or if it even matters! This is a lot larger than the Sherline I am used to.
Does the 250 refer to the size?
Thanks!
Dave D
The knurl holder is marked 250-110, the cutoff tool is marked 250-107 and the toll holder is marked 250-101.
I have been looking at Ebay and other sellers and I think this is the BXA version. If so, are they pretty much all compatible between sellers? I don't know enough about these to even tell if it is a wedge type or piston type or if it even matters! This is a lot larger than the Sherline I am used to.
Does the 250 refer to the size?
Thanks!
Dave D