Hello, I bought a 6913 Clausing 48" and was in the process of rebuilding and repainting the lathe. I bought a new lead screw, worm, some bushings. After I got it painted and started to reassemble it I noticed the carriage does not move along the ways when you set the shims and clamps and you...
Machining operations often generate some plastic waste. Companies often collect this waste and try to use it by putting a small percentage of waste in with the virgin plastic. The problem is that the rate of generating scrap exceeds the ability to reuse it. Other companies simply write it off...
I got my new 5C collet chuck mounted to the G4003G and it is showing .0005 TIR indicating on the inside surface of the chuck nose (taper that closes the collet). I put a collet in and a accurate test bar (protruding 5 ") , indicates .0006 TIR at the nose of the chuck. Then indicated 4" out...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.