-
Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!
vise alignment
-
Milling Vise Alignment In 13 Seconds
I rarely remove the vise from the milling machine - just too much fussing around to get it back parallel to the table axis. A recent project required several change-outs of vise and hold downs - so I came up with something that gets my vise alignment down to a few seconds, rather than the 3-5...- gr8legs
- Thread
- vise alignment
- Replies: 56
- Forum: ALL ABOUT METROLOGY - MEASURE, SETUP & FIT