-
Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!
80IPM Cobalt R/F endmill and Mach3 and In a garage also
- Thread starter jbmachine
- Start date
- Joined
- Jun 17, 2012
- Messages
- 22
It is an Acra mill -
Nema42 aerotech servos
Nema34 HSM servo
AMT102 encoders
CNC DRIVE Dugong Drives
CNC DRIVE HDBB
WJ200 3PH - 3PH 3HP VFD
Gear Belt conversion - 2:1
Max rpm 5100
NMTB30 Taper
Mach motion style console
Custom Screenset
Programed via Mastercam and custom post to use M998 tool change pos. in settings in mach3
may upgrade to 5hp motor and vfd for more muscle
Use to be a Handyman CNC with centroid controller re branded but it was DOA when I bought it
Did all the upgrades for the new controller
Nema42 aerotech servos
Nema34 HSM servo
AMT102 encoders
CNC DRIVE Dugong Drives
CNC DRIVE HDBB
WJ200 3PH - 3PH 3HP VFD
Gear Belt conversion - 2:1
Max rpm 5100
NMTB30 Taper
Mach motion style console
Custom Screenset
Programed via Mastercam and custom post to use M998 tool change pos. in settings in mach3
may upgrade to 5hp motor and vfd for more muscle
Use to be a Handyman CNC with centroid controller re branded but it was DOA when I bought it
Did all the upgrades for the new controller