Armstrong tool holders

[OldFatMan]

Anyone have any use for these?
Armstrong #2S, #2R, #31R (2), #1L, #1S
A couple have tools, a couple have some minor shop made modifications. All have all the hardware they are supposed to have.

 

[Uglydog]

I might be interested in the 1L and 1S.
Those should be 1/2" shank. Is that correct?
Are those two fully functional? I'm not very concerned about pretty.
Any idea what $ you might be asking?

Daryl
MN

 

[OldFatMan]

I’ll get out to the shop in a bit to check but if you are talking the vertical dimension of the holder I believe they are larger than 1/2”.

 

[OldFatMan]

The 31R and #1 tool holders are 1/2” wide but about 1 1/8” high. I’d rather trade the lot.