Bench-Master spindle

cross thread

Registered
Registered
Joined
Apr 5, 2013
Messages
391
Hi , I recently got a Bench-Master MV-1 . It was rough , luckily I got it before it was too late . Sorry I didn't take any before pictures , worst was the table . Very rusty and after clean up , an area about the size of two postage stamps was heavily pitted . I'll take some work in progress pictures later today , question I have right now is , what is the part number for the upper (small) Timken bearing for the spindle ?
Thanks , Mark .
 
If you can measure the id. and od. I have had good luck matching a new one in a bearing catalog or at a bearing supply house. If you’re real lucky there may still be an identification marking on the bearing it’s self. We all love pictures.
 
Hi @Nutfarmer , the bearing is still in the head so I can't do anything with it . I will be taking it to a shop that does press work , I would like to get all the new bearings together before I go . Also a nice thing about the Timkens is that the part number is on the inner race .
Thanks , Mark .
 
Back
Top