Commissioning a new COREXY printer build. 20mm calibration cube. I missed tightening a pulley. LOL!
jbolt Active User H-M Supporter Gold Member Jul 21, 2022 #1 Commissioning a new COREXY printer build. 20mm calibration cube. I missed tightening a pulley. LOL!
markba633csi Mark Silva H-M Supporter Gold Member Jul 21, 2022 #2 LOL well it reminds me of a cube, sorta
N Nutfarmer Registered Registered Jul 22, 2022 #4 Just proves we are not perfect. So what is new? The only person that doesn’t make a mistake is the only person that doesn’t do anything.
Just proves we are not perfect. So what is new? The only person that doesn’t make a mistake is the only person that doesn’t do anything.
great white Active User Registered Jul 24, 2022 #6 3d printer fails always remind me of this 3d benchy vid: https://www.reddit.com/r/3Dprinting/comments/i7erj1 Funny!
3d printer fails always remind me of this 3d benchy vid: https://www.reddit.com/r/3Dprinting/comments/i7erj1 Funny!
jbolt Active User H-M Supporter Gold Member Jul 24, 2022 #7 great white said: 3d printer fails always remind me of this 3d benchy vid: https://www.reddit.com/r/3Dprinting/comments/i7erj1 Funny! Click to expand... That's hilarious!
great white said: 3d printer fails always remind me of this 3d benchy vid: https://www.reddit.com/r/3Dprinting/comments/i7erj1 Funny! Click to expand... That's hilarious!
T tweinke Active User H-M Supporter Gold Member Jul 24, 2022 #8 hard to measure but its on size right?