SB 13 carriage handwheel.

[Ultradog MN]

I got the SB 13 home.
I see the carriage/ apron handwheel is cracked.
I could fix it but would buy a good one if I can find one.
What other size SB lathes used the same size?
Thanks

 

[gard]

I have a copy of SB parts list, from off the web someplace. there is a note , #26 with any gearbox except wide range and #69 with 4 to 480 thread range, I suspect this is because the handle is supplied as an assembly with the pinion shaft and drilled holes for taper pin.
part number for #26 on 13" lathe is AS1263T1, same for other lathes except the T changes to R, F and H for 10, 14 1/2 and 16 inch lathes respectively..

I have a 14 1/2 inch lathe the outside dia of handle is 7.5" and shaft appears to be 5/8, estimating thru a layer of paint.
The 10L lathe is 5 5/16 OD and 9/16 shaft.

You can compare your 13' to the 10 and 14 1/2 but I am guessing it will be different

 

[SLK001]

If you're talking about the part pointed at by the red arrow, then pretty much each lathe had a unique size for the hand wheel. Your particular machine's Unit Number for that part is: AS1263T1. Thirteens are fairly common, so you should have good luck finding one.