I see a (magnet?) just prior to 0*...how many degree separation there? How far in from edge are 1/8” holes? Seems pretty straight forward, but as I’ve used my indexer 5 times since purchase...well, your risking a lot at altitude! I had to get help here just with indicating it in. Where I’m very green, I’m not going to sugar coat, but yeah, pretty straight forward directions.
The 1/8 holes are at 0, 180, and 220. I will install the magnets at home. The magnet at 220 is opposite polarity so that the ignition system knows where it is at. These positions have nothing to do with degrees from top dead center as the ECU is going to figure that out on it's own.
How far from the edge are the 1/8 holes: It's not critical. I will adjust the pick-up to set over that radius as needed later.
You more than likely have a 90 turn indexer which means you would drill at 0, 45, and 55 turns. The good news is you will not have to center
the indexer to drill the holes.
I'll have the pipe parts in the mail Monday.
More info at :
SonexFlight Podcast: Episode 58 - SDS EFI for your AeroVee
www.sonexflight.com
Thanks again for the help,
Curry