Greets to all! Have been using the mill off and on for some time now - VERY nice piece 'o kit (as the Brits would say). Recently I've been having an odd issue: when I tighten the X-axis locking screw (front of table) the Y-Axis locks up as well! Just took out all the X-Y gibs, cleaned and stoned, returned - Problem still persists. I would think with one axis locked, the other should move freely. Not quite - I can lock Y-axis (side, under table) and X still moves fine. But if I tighten the X-axis lock (front) BOTH axis's lock up!
Any ideas what might be going on?
Any ideas what might be going on?