Brake lever shaft.. mine again needed to have a slight grind done to allow it to be installed.
Reinstall the roll pin through the brake operating cam.
Slide the brake operating came over the end of the brake lever shaft.. then slide the brake lever shaft the rest of the way in place.
Lightly lube the brake lever shaft and install. Leave enough room to install the brake operating cam.
Brake lever shaft.. mine again needed to have a slight grind done to allow it to be installed.
Housing with brake operating finger pivot stud...and brake operating fingers installed.
Install the set screw for the brake operating finger pivot stud.
Install the brake operating finger pivot stud with the brake operating fingers like so.
expressline99

Brake lever shaft.. mine again needed to have a slight grind done to allow it to be installed.

Media information

Album
Bridgeport Series 1 VS 2hp belt housing tear down and rebuild
Added by
expressline99
Date added
View count
512
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/3.5
Focal length
6.3 mm
Exposure time
1/43 second(s)
ISO
400
Flash
Auto, did not fire
Filename
DSCN5513.JPG
File size
2.2 MB
Date taken
Fri, 14 April 2017 6:55 PM
Dimensions
3648px x 2736px

Share this media

Back
Top