Time to install the new bearing. Press it into place on this side. Press on the outer race when install it into the brake bearing cap.
Bearing spacer ring that goes on the brake bearing cap after the cap has been installed.
Press the brake bearing cap into place on the stationary vari-disc pulley. Press only on the INNER race of the bearing this time!
Make sure the bearing is completely flush in the brake bearing cap.
Time to install the new bearing. Press it into place on this side. Press on the outer race when install it into the brake bearing cap.
Bearing numbers from the new bearing. Again...you really should replace this bearing while you are in here!
Time to press out the old bearing. Press it out from the side shown.
Stationary vari-disc pulley after the brake bearing cap has been removed.
expressline99

Time to install the new bearing. Press it into place on this side. Press on the outer race when install it into the brake bearing cap.

Media information

Album
Bridgeport Series 1 VS 2hp belt housing tear down and rebuild
Added by
expressline99
Date added
View count
435
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/3.5
Focal length
6.3 mm
Exposure time
1/28 second(s)
ISO
400
Flash
Off, did not fire
Filename
DSCN5553.JPG
File size
2.2 MB
Date taken
Fri, 14 April 2017 7:49 PM
Dimensions
3648px x 2736px

Share this media

Back
Top