You can now slide on the motor casing lining up the wires and pulling them through as shown.
The motor fan shrowd screws. With a spacer and rubber bushings.
The long screws that hold the motor top plate on.
Pull the wires through the motor top and install it using the 4 long screws. Do this before putting the motor casing back on.
You can now slide on the motor casing lining up the wires and pulling them through as shown.
After you press the rotor into the motor base. you can carefully slide the stator/windings and casing on. Make sure you line up the marks from earlier
Motor base. Time to install the rotor and stator/casing. There is a spring washer that goes in here before you press the rotor in.
New bearings pressed on to the rotor ready to go!
expressline99

You can now slide on the motor casing lining up the wires and pulling them through as shown.

Note before this you have to install the motor top... because the wires need to go through it first. I made this mistake. oops.
Click to expand...

Media information

Album
Bridgeport Series 1 VS 2hp Motor Tear Down and Bearing replacement
Added by
expressline99
Date added
View count
487
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/3.5
Focal length
6.3 mm
Exposure time
1/30 second(s)
ISO
200
Flash
Auto, fired
Filename
DSCN5853.JPG
File size
2 MB
Date taken
Thu, 08 June 2017 6:22 PM
Dimensions
3648px x 2736px

Share this media

Back
Top