I have a WW2 era 13" LeBlond 'trainer'. It needs the feed reverse idler gear in the headstock. One tooth is broken off.
It also needs the end support for the leadscrew and feed rod, or I could make one with a dimensioned drawing.
I don't have a serial number because for some reason Idaho State University ground it off the pad at the right end of the bed and engraved their own asset number, also scratched ISU and the number into the paint on the headstock dial. I know it's WW2 vintage from the remains of the WAR FINISH label on the headstock.
I'd love to get some good pictures of those labels so I can make a reproduction to put on the lathe after it's restored.
It also needs the end support for the leadscrew and feed rod, or I could make one with a dimensioned drawing.
I don't have a serial number because for some reason Idaho State University ground it off the pad at the right end of the bed and engraved their own asset number, also scratched ISU and the number into the paint on the headstock dial. I know it's WW2 vintage from the remains of the WAR FINISH label on the headstock.
I'd love to get some good pictures of those labels so I can make a reproduction to put on the lathe after it's restored.