- Joined
- Nov 29, 2015
- Messages
- 439
OK I gave practice scraping a shot. This was on a piece of scrap CI I had laying around. ...I spent forever and learned I do a lot of side gouging. Anyhow....8hrs on something that has no use on purpose. Gotta learn before I touch those machines! I did not mill this flat...milling machine table still in pieces. So there were band saw lines and it was a sloppy mess. I will mill before I try again and it will be on a usable tool of some sort.
Don't slaughter me I'm being brave throwing these out there. I'm not impressed with how it looks either. But it's a start.
Paul
Don't slaughter me I'm being brave throwing these out there. I'm not impressed with how it looks either. But it's a start.
100 passes. Between 90 and 100 I started using a much smaller scraper blade..and lots sharper. It took material off quickly.
Here it's hard to see the break up but the amount of bearing is tons higher than 10 passes ago...
Paul