First snag.. Thermal Overload fault just after setting up the DuraPulse GS3-22P0 VFD using the quickstart guide. Same Marathon
145THTR15540 motor that I've been using without fail with the Delta VFD, so obviously I am either missing something or set it up wrong.
I am unsure about the "ohms" section on the nameplate and how to determine which number to use when setting up the VFD. I chose 4 ohms as a rough average of what is described on the nameplate but perhaps it needs to be quite different. The other thing that may have caused the "Thermal fault" is the AMP rate I used may be lower than what is appropriate for 230 volt. I believe I set it for 2.4 however maybe I need to use the maximum of 4.8 amps for 230v. Can't see straight, gotta get some zzzz's. gnite
Jake
145THTR15540 motor that I've been using without fail with the Delta VFD, so obviously I am either missing something or set it up wrong.
I am unsure about the "ohms" section on the nameplate and how to determine which number to use when setting up the VFD. I chose 4 ohms as a rough average of what is described on the nameplate but perhaps it needs to be quite different. The other thing that may have caused the "Thermal fault" is the AMP rate I used may be lower than what is appropriate for 230 volt. I believe I set it for 2.4 however maybe I need to use the maximum of 4.8 amps for 230v. Can't see straight, gotta get some zzzz's. gnite
Jake
Last edited: