- Joined
- Aug 11, 2020
- Messages
- 45
I've been kicking around wetting my left little toe into the CNC waters. I went as far as posting to this forum, asking which computer to buy and which CAD to run. I grabbed a couple Kindle Unlimited beginning CNC books to read. In general, when dreaming adventurously I was thinking about the $250 desktop cnc router on Amazon to play around with while I built my retirement house.
Through some crazy mistakes by my mortgage company I ended up getting a gift card that needed to be cashed out by the end of month and would take two acts of God and probably the underwriter to cash it out or apply it to the loan. So my taxes are paid, I own my old car outright, and my kids and grandkids got shoes, so what could I do?
I decided what the heck, be bold grasshopper, both feet in all the way to my eyeballs and I ordered a new PM-30MV from Precisionmatthews.com and the hardware CNC kit from Arizonacnckits.com.
OMG, what have I done? That is the whole gift card AND everything I know about CNC conversions too.
To be continued...
Through some crazy mistakes by my mortgage company I ended up getting a gift card that needed to be cashed out by the end of month and would take two acts of God and probably the underwriter to cash it out or apply it to the loan. So my taxes are paid, I own my old car outright, and my kids and grandkids got shoes, so what could I do?
I decided what the heck, be bold grasshopper, both feet in all the way to my eyeballs and I ordered a new PM-30MV from Precisionmatthews.com and the hardware CNC kit from Arizonacnckits.com.
OMG, what have I done? That is the whole gift card AND everything I know about CNC conversions too.
To be continued...