I bought a mill with a 3 phase motor:220v, 60Hz, 8.9a, YCF 2.2-4
I'll be powering it from 220v single phase. & my power actually runs around 240v+.
I also bought a VFD from eBay
http://r.ebay.com/b59D0p
The manual for the VFD is here: https://drive.google.com/file/d/0B49xwe9ffk3fZ3VWR3NHMjB6VkU/view?pli=1
Reading the manual I'm finding there is much of it over my head. Would there be any of you that are knowledgeable with these that would be willing to help me program it? I have no idea what would be a good starting point & stopping point when programming the ramp up or down voltage & Hz. Breaking out any of these things that look important. Also should I use the VFD or the machines switch for reversing the motor?
I can handle the writing part.
I'll be powering it from 220v single phase. & my power actually runs around 240v+.
I also bought a VFD from eBay
http://r.ebay.com/b59D0p
The manual for the VFD is here: https://drive.google.com/file/d/0B49xwe9ffk3fZ3VWR3NHMjB6VkU/view?pli=1
Reading the manual I'm finding there is much of it over my head. Would there be any of you that are knowledgeable with these that would be willing to help me program it? I have no idea what would be a good starting point & stopping point when programming the ramp up or down voltage & Hz. Breaking out any of these things that look important. Also should I use the VFD or the machines switch for reversing the motor?
I can handle the writing part.