I have a new to me 4910 lathe that I put a AXA tool post on. Was looking at purchasing some
carbide insert tool holder because in a box of stuff I bought I found a box of CCMT 06-02-02 inserts.
Does anyone have any experience with this and what shank size tool holder I should buy for the
inserts I have. I like the idea of 1/2 inch holders but am wondering if I can get the insert low enough
to center the cutting edge.
carbide insert tool holder because in a box of stuff I bought I found a box of CCMT 06-02-02 inserts.
Does anyone have any experience with this and what shank size tool holder I should buy for the
inserts I have. I like the idea of 1/2 inch holders but am wondering if I can get the insert low enough
to center the cutting edge.