- Joined
- Feb 2, 2013
- Messages
- 95
I've finally gotten around to cleaning the motor out and replacing the rubber mounts. I also picked up a link belt for the press. I am not sure I like how it runs with it. It almost seems a bit loud. It doesn't fit deeply into the pulley and I am thinking that it makes a bit of noise and maybe even some vibration. I am thinking of ditching it, but figured I would try here for opinions on these link belts. I used them successfully with my craftsman lathe, but in this application seems a bit loud. I would prefer it to be whisper quiet if possible. Any suggestions?
Thanks
Bob
Thanks
Bob