- Joined
- Jul 26, 2014
- Messages
- 93
Hello All;
I have an issue with my 4” x 6” metal cutting band saw that I hope someone can help me with?
The issue is the blade keeps jumping off the lower wheel when cutting at an angle or when cutting tubing. It is as thought the blade gets pinched or the cutting is interrupted.
I have been unable to remove the lower wheel even though I removed the retaining clip and grub screw.
The saw is very difficult to set up to track properly but when done it cuts at a nice 90 degree angle.
I have spent many hours trying to get this machine to operate better but have had limited results. I have changed blades, adjusted the upper wheel, adjusted the guide bearing as well as the dovetail holders on the blade arms.
I hope someone might assist me with this very frustrating situation?
I have an issue with my 4” x 6” metal cutting band saw that I hope someone can help me with?
The issue is the blade keeps jumping off the lower wheel when cutting at an angle or when cutting tubing. It is as thought the blade gets pinched or the cutting is interrupted.
I have been unable to remove the lower wheel even though I removed the retaining clip and grub screw.
The saw is very difficult to set up to track properly but when done it cuts at a nice 90 degree angle.
I have spent many hours trying to get this machine to operate better but have had limited results. I have changed blades, adjusted the upper wheel, adjusted the guide bearing as well as the dovetail holders on the blade arms.
I hope someone might assist me with this very frustrating situation?