- Joined
- Nov 29, 2015
- Messages
- 439
Hi guys, I'm about to remount the motor on my power feed to the gearbox. At some point someone told me using a bit of RTV is recommended for the area around the mounting flange. Just where the mating surfaces are and in the two reset screw holes. But I forget what type of RTV. It was either red or blue. One was said to get into the gearbox and one not so much... any ideas?
Also, there appears to be a recessed area around the base of the shaft for a large o-ring? This is the area just before the first rise in height from the mounting plate. Looks to be about 2-3/4" ? I can't find any diagrams that show an o-ring there and I assume using the RTV will take care of this anyway.
Thanks,
Paul
Also, there appears to be a recessed area around the base of the shaft for a large o-ring? This is the area just before the first rise in height from the mounting plate. Looks to be about 2-3/4" ? I can't find any diagrams that show an o-ring there and I assume using the RTV will take care of this anyway.
Thanks,
Paul