Hello Bruno,
Thank you for the welcome.
Here is some more details I hope will help, I supplied the computer and downloaded the drivers, I am pretty sure of this.
Ok so all of the components are Keling tech or at least what I have found says so. The power supply is a KL-350-36 I have metered it and it is supplying 64.6 v to the Keling-4030 controllers(there are 3 of them x,y,z.) it also has 5.22 v going into the pul+, it has5.22 go in into the dir+. It also has 3.76 at the pul- and the dri-. At the c10 parallel port interface card it has at pin2 -7, 3.75v. This is not hooked up to the computer with these readings. On the parallel port of the computer pin2 in reading 4.63v and goes to 4.64 when the arrow is pressed on the keyboard. Pin3 is reading .18v and when the narrowest is pressed it goes to 4.87v. Pin4 and pin6 are the same as pin2, and pin5 and pin7 are the same as pin3. The motors are KL-23h276-30-8B. Yes I have visited Keling techs website and followed there diagrams. Unfortunately the people I bought it from had no info or paperwork, so I am going by what I can find online. Hope this is what you were talking about. Any help would be greatly appreciated,
Nick