- Joined
- Oct 5, 2013
- Messages
- 20
Hello everyone,
just checked my PrincessAuto (read HarbourFreight) mini mill chuck and found a cause for 0.008" mill bit deviation.
Here is the offending part:
As you may see something went wrong and that piece of metal is uneven.
Would it be ok just remove it on lathe?
I do not see that part is responsible for anything, is not it?
just checked my PrincessAuto (read HarbourFreight) mini mill chuck and found a cause for 0.008" mill bit deviation.
Here is the offending part:
As you may see something went wrong and that piece of metal is uneven.
Would it be ok just remove it on lathe?
I do not see that part is responsible for anything, is not it?