- Joined
- Dec 2, 2012
- Messages
- 1,729
Would using just 2 wires on one side work? Seems like it should be the same after figuring out what the dimension should be, if a sample thread was available it should just be a comparison type measurement. What say Ye?
I miss read your post I have a bit of a cold, yeah i've seen that mentioned before i can't remember when the up shoot was, I think by using wires on both sides your eliminating the need to account for any under size that may have been applied to the major diamitor to achive the desired fit, i.e. Your not mesuring the root or the od of the thread. Just the pitch diamitor.
Stuart