- Joined
- Jan 29, 2013
- Messages
- 114
For those interested, I am going to post the instructions that Richard sent me and others his method of tailstock to headstock alignment as well as the evaluation of one other occasionally used method that he had heard about. I will post this under a new thread in the Machine way scraping and restoration though it might be better in the Metrology section, but Richard doesn't moderate that one, and since it could go under others that's just where I'll put it. If anyone knows how to make it an article, it would be good to do that. Anyway check this link here to get to the method he uses:
http://www.hobby-machinist.com/show...-Tailstock-with-Headstock?p=106737#post106737
http://www.hobby-machinist.com/show...-Tailstock-with-Headstock?p=106737#post106737