- Joined
- Jan 21, 2013
This is a set of videos from Lars that starts with a broad overview of Fusion, and then goes on. Not a bad place to start.
Fusion 360 for Beginners Playlist
Fusion 360 for Beginners Playlist
They recently changed the UI so everything will look different from the tutorial now. Shouldn't take too long to figure out were things are now, but I can see how that could be inconvenient.
Thank you for the reply. I had two computers going, one to watch and one to follow along. When they came up different I had to do a lot of backing up. I could get the result but I don’t think it was always pretty the way I did it. For instance, I didn’t have fillet radii where they we supposed to be and then ended up with them everywhere. Had to back up a lot to fix that. Now I am pulling the hole and that is a challenge as was when we looked at the section view, trying to get that back....ugh. Will just take fussing with.They recently changed the UI so everything will look different from the tutorial now. Shouldn't take too long to figure out were things are now, but I can see how that could be inconvenient.