- Joined
- May 21, 2022
- Messages
- 12
I recently made some first chips with my converted G0704, and learned a lot on the first few go runs (like double checking step down/overs before hitting the GO button). I noticed that the X-Axis is way harder to turn by hand than the other axes. Z-Axis is smooth as butter, no problems. Y-Axis is a bit tight, but can be turned freely. The X-Axis is super tight. To the point that I lose steps every once and a while. I think I have it narrowed down to the table ends are too high, and causing it to bind/bow the screw. Is this something anyone else has run into in the past? Is the only/best solution to just make new table ends?