First of all, thanks for all the responses. I especially appreciate the individual that sent me the measurements from his machine. That is usable data.
To clarify couple of things, the four tool holder that came with the lathe is the correct size. The 1/2 inch tool being a 1/16 of an inch high is with the 4 tool holder and the QCTP (AXA) Phase II tha I have.
The issue is not with the tool holders, but the fact the compound is just too high. Manufacturing defect....
The cutting tool I am using is just a 1/2" high speed blank that I ground down. (And it is exactly 1/2" by 1/2")
And by the way, the individuals that suggested solving the problem with a QCTP really do not understand the purpose and/or function of the QCTP, especially when using the largest size cutter that it is made for. If the compound is above the normal spec. the QCTH will do nothing to resolve the problem with a 1/2" tool. That one is a thought statement. think about it. Hint- it does not lower tools, just raises them....
So the solutions provided were: - Suck it up and accept a defective tool... not acceptable to me
- rebuild the entire compound--- not acceptable to me
- buy and install a QCTP - -- Again, that will not fix the problem using a 1/2" tool
- Solution-- call Grizzly and request a new lathe (I was told new parts would not fix the issue by
Grizzly) This is the solution to my issue and I will call them tomorrow.
Have a great day and if you have a G0752 or equivalent from Grizzly, I recommend you check the height of the compound. If it is low, not an issue.
Regards,
JoJo1
View attachment 116092