- Joined
- Dec 25, 2011
- Messages
- 591
I went and looked at a Grizzly G3616 today and put a deposit down on it. Will pick it up in a week or so. Owner says his dad has forklift to load it on my trailer---I just have to figure out how to get it off I have a 2 ton HF hoist and hopefully can do it with the hoist. I think it weighs about 1200-1300 lbs. It comes with what it did new, vice, R8 collet set, drill chuck.
Any and all suggestions for unloading are appreciated.
I have to get my shop wired for it. I have already run 10 gauge wire to the spot, just have to dig it out from behind the insulation and wire the outlet box and get a 20 amp 220v breaker.
And I hate driving in Dallas traffic==I live about 100 miles from there.
Any and all suggestions for unloading are appreciated.
I have to get my shop wired for it. I have already run 10 gauge wire to the spot, just have to dig it out from behind the insulation and wire the outlet box and get a 20 amp 220v breaker.
And I hate driving in Dallas traffic==I live about 100 miles from there.
Last edited: