- Joined
- Jan 20, 2021
- Messages
- 296
I have the Accuslide running OP2 on some production parts.
The timelapse is deceiving. It's a six minute cycle. The nature of the setup, stickout, tool, etc mean I take 0.015 depth of cut at 8in/min. I'll take reliable and slower over fast and problematic every single time.
Parts are looking good as well. They get tumbled, so it's not a big deal to have a small surface finish anomaly.
This is the current tool setup. It may be in this configuration for a very long time now that it's working!
The timelapse is deceiving. It's a six minute cycle. The nature of the setup, stickout, tool, etc mean I take 0.015 depth of cut at 8in/min. I'll take reliable and slower over fast and problematic every single time.
Parts are looking good as well. They get tumbled, so it's not a big deal to have a small surface finish anomaly.
This is the current tool setup. It may be in this configuration for a very long time now that it's working!